DeWalt DXV20P User Manual

9
English
STORAGE (Fig. A)
1. Empty dust tank, refer to TO EMPTY DUST TANK
instructions.
2. Clean the vacuum inside and outside. refer
to CLEANING.
FILTER.
4. Store the hose and the power cord, as
shown in the Fig. A. Place the appliance in
a dry room and secure it from unauthorised use.
BLOWING FEATURE (Fig. C)
The vacuum contains a blowing feature. It has the
capability to blow sawdust and other debris. It can
be used to blow dust and debris out of garages or off
patios and driveways. Follow the steps below to use
the vacuum as a blower.
1. Locate blowing port on the vacuum.
2. Insert one end of the hose into the blowing port.
3. Turn vacuum “ON”.
OPTIONAL ACCESSORIES
WARNING:
Since accessories, other than those
offered by D
EWALT, have not been tested with this
product, use such accessories with this appliance
could be hazardous.
To reduce the risk of injury, only D
EWALT
recommended accessories should be used
with
this product.
CLEANING
TROUBLESHOOTING
WARNING
:
TO REDUCE THE RISK OF INJURY FROM
MOVING PARTS AND/OR ELECTRICAL SHOCK,
TURN POWER SWITCH OFF AND DISCONNECT
GROUNDED PLUG FROM ELECTRICAL OUTLET
BEFORE PERFORMING TROUBLESHOOTING
CHECKS.
customer service.
To keep the wet/dry vacuum looking its best, clean
the outside with a cloth dampened with warm water
and mild soap.
To clean the tank:
1. Dump out debris.
2. Wash tank thoroughly with warm water and mild
soap.
3. Wipe out with dry cloth.
WARNING: To avoid injury to bystanders, keep
them clear of blowing debris.
WARNING: If the supply cord is damaged, it must
be replaced by the manufacturer, its service agent or
PROBLEM SOLUTION
Motor does not run
Check power cord, plugs and outlet.
Ensure the on/off switch is in the
ON position ( I )
nozzle, extension wands, hose
Replace the disposable dust bag.
Empty dust tank, refer to
TO EMPTY
THE TANK under OPERATING
INSTRUCTIONS.
Check for proper installation of
Suction capacity
decreases
Vacuum stops
running
Thermal overload has been tripped:
1. Turn the vacuum off and
disconnect vacuum cleaner from
power source.
2. Empty the dust tank, if needed.
3. Allow the unit to cool.
4. Plug the power cord into an
appropriate outlet and turn on/off
switch to the ON position ( I ) to
test.
replace if necessary.
are secure.
Check for proper installation of the
Dust comes out
while vacuuming

DeWalt DXV20P Specifications

General

Brand	DeWalt
Model	DXV20P
Category	Vacuum Cleaner
Language	English