Dexter Laundry T 30 express Series User Manual

4
Dryer Error Codes
Symptom Probable Cause Suggested Remedy
TEMP SENSOR
SHORT
Shorted Temperature
Sensor or wire.
The dryer control shall not start until
the detected short circuit is removed.
Regardless of condition of short circuit,
Error Code will be displayed until
programming button is pressed to return
machine to idle mode.
TEMP SENSOR
OPEN
Open Temperature
Sensor or wire
The dryer control shall not start until
the detected short circuit is removed.
Regardless of condition of short circuit,
Error Code will be displayed until
programming button is pressed to return
machine to idle mode.
PCB ERROR1 Memory corrupted Power machine down and try to reset
control. Varify voltage to the control
board. Check ground to board. Replace
control board if error can not be cleared
PCB ERROR2 Analog/ Digital Error Power machine down and try to reset
control. Varify voltage to the control
board. Check ground to board. Replace
control board if error can not be cleared
COMM ERROR1 Communication Bus
Error
Power machine down and try to reset
control. Varify voltage to the control
board. Check ground to board. Replace
control board if error can not be cleared
COMM ERROR2 No Dryer Model Selected This error occurs when a pin combination
on the model selection header is used
that does not have a model designated
for it. check connector marked Jumpers
on the control board.
COMM ERROR7 Communication Bus
Error
If connected to DexterLive, Disconnect
cable, and preform a soft restart by
holding down the program button on
power up.
Preform Soft restart.
contact your Dexter factory representive.
Fuse Error Internal Control program
Error.
Internal IC issue. Replace control.
Part # 8533-076-001 11/13

Dexter Laundry T 30 express Series Specifications

General

Brand	Dexter Laundry
Model	T 30 express Series
Category	Dryer
Language	English