Need help?Do you have a question about the Deye SUN-6K-SG04LP1-EU and is the answer not in the manual?
General| Model | SUN-6K-SG04LP1-EU |
|---|---|
| Type | Hybrid Inverter |
| Rated Power | 6000 W |
| Max. DC Input Power | 8000 W |
| Max. PV Input Power | 8000 W |
| Max. DC Input Voltage | 500V |
| Max. PV Input Voltage | 500V |
| Start-up Voltage | 150V |
| MPPT Voltage Range | 120 V - 500 V |
| MPPT Range | 120 V - 500 V |
| Number of MPP Trackers | 2 |
| Number of MPPTs | 2 |
| Strings per MPP Tracker | 2 |
| Max. Input Current per MPPT | 13A |
| Rated AC Output Power | 6000 W |
| Max. AC Output Power | 6600 W |
| Max. Output Power | 6600 W |
| Rated Output Power | 6000 W |
| Peak Power | 6600 W |
| Rated AC Voltage | 230 V |
| Output Voltage | 230 V |
| Rated AC Frequency | 50/60Hz |
| Output Frequency | 50/60Hz |
| THDi | <3% |
| Battery Voltage Range | 40-60V |
| Battery Voltage | 48V |
| Protection Class | IP65 |
| Protection degree | IP65 |
| AC Voltage Range | 180-280V |
| DC Injection Current | <0.5% of rated output current |
| Communication | RS485 |
| Operating Temperature | -25°C to +60°C |
| Protection | Overvoltage, short circuit, overheating |
| Power Factor | ≥0.99 |
Explains the procedure and specifications for connecting the battery to the inverter.
Covers the procedures for connecting the inverter to the grid and backup load.
Details how to connect PV modules, including selection and wiring.
Illustrates the wiring diagram for single-phase parallel inverter setup.
Shows the wiring diagram for three-phase parallel inverter configurations.
Describes the procedure for turning the inverter on and off.
Allows configuration of battery type, capacity, and charging parameters.
Enables setting the inverter's operating mode (e.g., Selling First, Zero Export).
Configures grid connection parameters, frequency, voltage, and protection.
To Next Page