The batteries have a positive / negative polarity. If the battery does
not connect well with the device, do not try to insert it forcibly.
Do not use the Luer-type lock. If Luer-type lock connectors are
used in the construction of the tubes, there is a risk of accidentally
connecting to an intravascular flow system, allowing the pumping of
air into the blood vessels.
1.2 PRECAUTIONS
Do not disassemble, repair or make changes to the pressure
monitor or cuff.
Avoid high temperatures, moisture, dust and direct sunlight.
The casing of the device should be cleaned with a soft cloth
dampened in medical alcohol 75%.
Do not soak or clean the cuff with water.
After measurement, the cuff should be cleaned with a soft dry cloth.
Do not use in extreme high temperatures, high humidity or at high
altitudes. Use the device only in acceptable ambient conditions.
Do not place heavy objects on the power adapter or the device on
the cord.
Do not connect and disconnect the power adapter with wet hands.
Do not drop the device or expose it to strong shocks.
Do not use the device near large equipment that uses a relay for
ON/OFF type power switch.
If the device is not going to be used for an extended period of time,
remove the batteries.
Research on neonates, infants and pregnant women has not been
carried out. Do not use the measuring device on neonates, infants
and pregnant women.
The blood pressure monitor has been subjected to numerous
inspections to ensure measurement accuracy. The user should
perform the annual inspection and calibration of the device
recommended by the manufacturer.
Blood pressure measurements made by the device are equivalent
to those made by a qualified person using ausculatory method of
measurement with a cuff/stethoscope.
3
To Next Page