www.diamatic.eu 8/11 info@diamatic.eu
The choice of professionals
4. Initial operations
Before using the machine it is important to inspect the machine.
It is not permitted to use the machine if the machine safety is not according
the checkpoints below.
Checkpoints of electrical safety
Use only extension cables for extending the main cable that are sized
and marked in accordance with the overall power consumption of the
machine.
Electrical cables must be rolled entirely off of the reels.
Any damage to electric cables is not permitted
Use an electrical power supply connection with earth connection
Checkpoints of machine safety
Check if:
The safety functions and operating functions work correct.
The diamond wings are not damaged
There are not any damage to the electrical components.
There are not any loose nuts or bolts
There is not any damage to the dust hose and if it is connected
correctly.
Removing the diamond wings
Read chapter 3 Safety on page 6 & 7
Lay down the machine so it is laying on the metal support underneath
the electrical box. Make sure the machine will not fall back down. A
second person can stands on the handle to make sure the machine will
not fall back down.
Grab the diamond wings at the place where the gap in the Diamag plate
is and roll the wing over so the wing can be taken of the plate.
Mounting the diamond wings
Read chapter 3 Safety on page 6 & 7
Lay down the machine so it is laying on the metal support underneath
the electrical box. Make sure the machine will not fall back down. A
second person can stands on the handle to make sure the machine will
not fall back down.
Clean the Diamag plates so the diamond wings will connect well to the
plate.
Place the diamond wings one by one on the Diamag plates.
To Next Page
Loading...