www.diamatic.eu 9/11 info@diamatic.eu
The choice of professionals
5. Operating
When operating the Diamatic 735PRO, the following additional safety
instructions must be followed closely.
Switch on the machine
Turn on the dust collector before switching on the machine and
connect the dust hose to the machine.
Make sure the electric component box is
closed
Connect the power supply to the
connector (1)
Turn the main switch (2) to the right.
Stand behind the machine and hold the
handle tight.
Put the cord of the deadman switch (3) on
to your arm or put it on to your clothing.
Check the display (4) to make sure there
are not any faults or warnings.
Be sure that the emergency switch (5) is
turned up.
Turn the speed regulation button (6)
counter clockwise so the machine will turn
as slow as possible.
Turn the Left/Right button (7) to one of the
positions.
To start the machine, push the green Start
button (8).
Raise if necessary the speed of the
machine with the speed regulation button (6)
Switch off the machine
Push the red (emergency) button (5) on the electrical box.
Wait until the machine stops rotating.
Pull out the cord of the deadman switch (3)
Turn the main switch (2) to the left
Pull the power supply out of the connector (1)
Shut down the dust collector.
Operating during grinding
This machine will always have an even grinding result because of the
planetary system.
However it is advised to keep the machine constantly in movement for an
optimum grinding result.
For soft floors it is recommended to work on high disc speed, for hard floors
it is recommended to grind with low speed of the tools.
To Next Page
Loading...