Diamond Antenna K400 - User Manual

Installing the K400
The K400 can be installed on trunk lid, door or hatchback. Install the bracket on desired location as shown in the
following photos.
Trunk Lid
• Installing on trunk lid
The K400 bracket is basically installed as shown in
the following figure. To avoid damaging car body, use
protection plate.
bracket
car body
protection plate
set screw
hexagonal wrench (small)
Use set screws attached to install the bracket.
Hatchback or Door
• Installing on hatchback
Install the bracket on hatchback as shown in the above
figure with set screws and small hexagonal wrench.
To avoid damaging the car body, insert protection plate
into the place where set screws and the body contact.

Summary

Installing the K400

Trunk Lid Installation

Guides the installation of the K400 bracket on a car's trunk lid, emphasizing the use of a protection plate to prevent damage.

Hatchback or Door Installation

Details the process of mounting the K400 bracket on a car's hatchback or door, including bracket placement and protection.

K400 Bracket Tilt Angle Adjustment

K400 Parts List and Specifications

K400 Grounding Procedure

Diamond Antenna K400 Specifications

General

Mounting Style	Trunk/Hatchback
Impedance	50 Ohms
Polarization	Vertical
Connector Type	NMO
Type	Mobile
VSWR	1.5:1
Height	40 inches