EasyManuals Logo

Diamond Antenna D130J User Manual

Diamond Antenna D130J
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
OPERATING MANUAL
0130J/0130NJ Super Oiscone Antenna for Wideband Reception
The 0130J/D130NJ Super Discone Antenna is
the first ultra-wideband antenna
in
the market
which can cover amateur radio, air traffic
control and other various utility frequency
bands and,
in
addition, even some amateur
radio frequency bands within the covering
frequency range can be transmitted with this
antenna alone. The D130J/D130NJ is
designed to
be
able to assemble very easily
and can be built
in
a couple
of
hours by
beginners. Rust free stainless steel is
employed
in
major component parts to have
the antenna rust resistant and durable. And its
very compact and lightweight design enables it
to be installed at any convenient place.
Assembling the 0130J/0130NJ Super Oiscone Antenna
Description
1.
Ultra-wideband design to be able to cover
25-1300MHz.
2.
Very compact and lightweight design
enables the antenna to be installed on
balcony railing at
an
apartment or
condominium.
3.
6m,
2m
70cm and 23cm amateur
frequency bands and 33cm band
(900MHz) can
be
transmitted.
4.
Since all radial rods are designed to have
the same length, the D130J/0130NJ is
perfectly omnidirectional as original
discone antenna and can receive radio
propagation from any direction evenly.
5.
The D130J/0130NJ can be made further
compact and lightweight by removing the
top element assembly, if it doesn't require
to
receive lower end frequency range.
Specifications
Frequency range: 25-1300MHz for receiving
only (Amateur frequency
bands and personal
radi.o
frequency band for trans-
mitting)
Length
:1.7m (66.9")
Weight :1kg (2.21bs.)
Max. Diameter : 0.84m
(33")
Number below each part name
is a part number
Coaxial cable is not included.
Set screw
01010
Spring washer -
01011
~-----~-~
Hexagonal wrench
---~"""
01008
Set screw 01009
Turn set screw until it stops lightly
and then turn it about one and
half turn
to
fix radial element rod
and to avoid disconnecting the
element.~
Filled
part
of each radia /
V
.....
-,,
element
rod
has to
be
set upward.
.....___
______
_
/
Radial
element rod
,,
820mm (32.3") /
I 01005 I
\ J !
'
/~:ch
cap has to be '
attached to the empty
side of the rod.
r
Cap(small)
01015
LTop
element
11
01001
Disc element rod 01004
280mm ( 11.0")
These disk element rods have to be assembled
after radial rods have been assembled.
After putting apex assembly out from the package,
detach support pipe from the assembly
by
removing
three M3 screws. Then connect coaxial cable to
coaxial receptacle at the bottom of apex assembly
through support pipe as shown
in
the illustration.
--~--
Applical91e
mast diameter
25
to 52mm (0.98 to 2.05")
V-bolts
Mast diameter accepted: 25-50mm (0.98"
to
2.05")
Max. Power rating: 20W
FM
(6m), 50W PEP (6m)
200W
FM
(except for 2m)
Coaxial cable
is
not included.
Type
: Wideband Omnidirectional
discone antenna

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Diamond Antenna D130J and is the answer not in the manual?

Diamond Antenna D130J Specifications

Frequency and Power IconFrequency and Power
frequency range25-1300MHz
max power rating (6m FM)20W
max power rating (6m PEP)50W
max power rating (except for 2m FM)200W
Weight and Dimensions IconWeight and Dimensions
length1.7m
weight1kg
max diameter0.41m
mast diameter accepted25-50mm

Related product manuals