CP6
6 Band Trap Vertical 80-6m
Instruction Sheet
The CP6A is a multi-band trap-vertical antenna for HF bands, covering the 80, 40, 20, 15, 10m & 6m amateur bands.
Made from heavy duty aluminum, the CP6 is easily assembled, yielding excellent performance and reliability from
a compact base station antenna.
Specifications
FREQUENCY: 80 – 40 – 20 – 15 – 10 – 6m
POWER: 200 Watts P.E.P.
IMPEDANCE: 50 Ohms
VSWR: 1.8:1 (Nominal). See table A for tuning.
ELEMENT PHASING: 1/4 Wave trap vertical groundplane.
GROUNDING: Direct Grounding. Antenna element & radials connected to mounting pipe.
MAX WIND RATING: 80 MPH (no ice)
MAX DIA ACCEPTANCE: 1.2 – 2.4 inches
OVERALL LENGTH: 15.10 feet (4.9kg)
WEIGHT: 9.9 lbs. (130 g)
CONNECTOR: SO-239 female UHF
Antenna Location & Mounting
The CP6 is a compact vertical antenna using loading-coil radials. The compact size offers many options on mounting
location. When choosing a mounting location, keep the following factors in mind:
(1) Resonant frequency of HF antennas can change based on location. Antenna should be mounted away from trees, build-
ings and other antennas.
(2) If mounting near house or balcony, best performance will be achieved if mounted at least 15 feet away from structure.
(3) To avoid unsafe conditions, do not install near electrical or power lines.
DIAMOND ANTENNA Products are distributed by RF PARTS COMPANY
435 S. Pacific Street • San Marcos, CA 92078 • (760) 744-0900
www.diamondantenna.net
To Next Page
Need help?
General
