11
The area where the cabinet is positioned must be clear and clean, preventing the refrigerator
equipment's fan from absorbing materials that are subsequently then deposited on the condenser's
ribbing, reducing system efficiency.
Remove the pallet, taking care not to knock the unit. The cabinet can now be levelled, screwing in
or unscrewing the legs. When it is levelled, the protection film can be removed from the stainless
steel using a blunt object, and not a cutter as it could scratch the steel.
(according to models)
There must be a gap of 50 mm at the back and 30 mm at the sides of the cabinet when it has been
permanently installed.
1.1 CLEANING
Now that our cabinet is correctly installed, we must proceed to cleaning it:
The first cleaning must be carried out with water and neutral detergent. Once clean and dry, insert
the accessories in the appropriate places, as you prefer.
We recommend cleaning the outside of the unit daily with a damp cloth and following the direction
of the stainless steel’s polished finish. Abrasive substances or those containing chlorine must not be
used. Rinse with clean water, avoiding direct water jets.
To Next Page
Loading...
