Page 16 ;&(%$*4.8"4,7%<'*#$"&8#=%/7*,#*%4,77%>?@@@?@AA?BCDC1 Item 64684
EF;6GH IJ6KFGLIM NFLMG6MFMO6E6GPJ
Q&(_/"*4*%,89%Q&(_%F(*,%E*$%P/
1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Route the power cord along a safe route to reach
the work area without creating a tripping hazard or
exposing the power cord to possible damage. The
power cord must reach the work area with enough
extra length to allow free movement while working.
3. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
4. Keep workpieces pressed firmly against
the Table and Fence while cutting.
5. Mark cut lines using waterproof marker or crayon.
M&$*- This tool is intended for use on
man-made masonry and tile products only.
;"77"83%$.*%Q,$*(%G(,V
1. Place the Drain Plug into the hole on
the bottom of the Water Tray.
2. Fill the Water Tray with clean water up to
the Maximum Fill Line before every use.
OFPGLIMc Water level must be kept above Minimum
Fill Line at all times during operation or damage
to the Pump and/or Saw Blade will occur.
R*8*(,7%I/*(,$"83%L8#$('4$"&8#
1. Adjust the Miter, Bevel, and Depth settings
as needed. Refer to previous page.
Lock all settings in place.
2. Place the workpiece on the Table and firmly
against the Miter Gauge and Fence.
3. Make sure the workpiece is clear
of the Blade and that the Switch
is in the off-position, then plug in the tool.
4. The Tile Saw is equipped with an On/Off Switch that
has a built-in locking feature. To turn the Saw ON:
a. Press the Reset Button on the Ground
Fault Circuit Interrupter (GFCI).
Indicator should turn on.
b. Press the Test Button. Indicator should turn off.
c. Press the Reset Button again,
then lift the ON/OFF Switch.
M&$*- Do not use if above test fails.
5. To turn the Saw OFF, press the
ON/OFF Switch down.
6. To lock the ON/OFF Switch, place it in the
OFF position and insert a padlock (not
included) through the hole in the Switch.
K*#*$%
S'$$&8
G*#$%
S'$$&8
R;OL
IM0I;;%
E)"$4.
G'(8"83%E,)%IM0I;;
;"77"83%Q,$*(%G(,V
U(,"8%J7'3
N,a"5'5%
;"77%T"8*
N"8"5'5%
;"77%T"8*