Page 17;&(%$*4.8"4,7%<'*#$"&8#=%/7*,#*%4,77%>?@@@?@AA?BCDC1Item 64684
EF;6GHIJ6KFGLIMNFLMG6MFMO6 E6GPJ
7. To turn on the Laser Guide, press
the Laser Switch marked with the
symbol. Press again to turn off.
To turn on the LED Light, press
the LED Switch marked with the
symbol. Press again to turn off.
8. With the Saw running, make sure the
Pump is supplying enough water to
the Blade. If needed, dry your hands,
turn off and unplug the Saw, adjust the
Pump′s flow, dry your hands again,
plug the Saw back in and turn on.
9. Let the Blade build up to full
speed before cutting.
10. Use two hands and hold
workpiece securely against Table
and Fence at all times. Feed
the material into the Blade.
11. When the cut is made, turn the Saw
off. Wait for the Blade to come to
a complete stop before removing
any part of the workpiece.
12. To prevent accidents, turn
off the tool and unplug the tool
from its electrical outlet after use.
Clean, then store the tool indoors
out of children’s reach.
E$(,"3.$%O'$
N"$*(%O'$
S*W*7%O'$
To Next Page
Loading...
