4 5
4.Press the Switch to start the machine.
Two suction speeds control.
a. Turn on the switch to use the low speed mode.
b. Press the button on the top cover to change to
high speed mode.
c. Press the switch again to stop the machine.
Ⅲ. How to use as a hand vacuum:
II. Use of water distribution tank
Insert the accessory(bristle brush or long crevice) to the main part as showed below until
hearing the click sound
I.Use as the stick vacuum cleaner:
1.Asse
1.Bond the square rag to the bottom of the water tank，Open the tank plug and inject tap
water on the tap or using a container
2 As shown in the figure, put the floor brush into the water tank and hear a "click" to
indicate that it is installed in place
mble the battery into the dust cup, make sure the battery bolt head is inserted
into the dust cup slot rightly as below.
2.Attach the metal tube to the main part as below until hearing the click sound.
3.Attach the power brush to the tube as showed below.
How To Use
How To Use
Battery Bolt head
Switch
High speed switch button
Dust Cup Slot
Water tank plug
Inject water
into the hole
To Next Page
Loading...
