5 6
Removal and installation of dust cup
Remove the dust cup from machine body: Push the push button under
the machine body forward, and the dust cup assembly will pop up. Then
rotate the dust cup assembly anticlockwise to take down the dust cup
Installation, disassembly and use
of product
low gear
blue
middle gear
purple
high gear
red
Use of accessories
Suitable for cleaning the hard surface such as floor and ceramic
tiles and the undercoat carpet.
Suitable for cleaning various household seams and
narrow positions in the car.
Suitable for cleaning the positions that need hair brush
such as curtain, car interior and air conditioner.
※Examples of using scenarios※
※Examples of use scenarios ※
※Examples of use scenarios ※
Quick dust removal due to the built-in independent motor and large plush
roller brush rotating at high speed
Flexible and thorough cleaning due to the horizontal rotation (270° ) and vertical
rotation (90° ) of floor brush
Cleaning of dark and dead angles such as the sofa bottom due to the front hi
gh-
light LED light
One-key extensible brush can suck and clean simultaneously and remove dust
efficiently.
Slim and soft hair brush can deeply clean the fiber and other household soft
decorations such as curtain and sofa.
The fine hair brush can deeply clean small seams such as key board and
meet the refined cleaning requirement.
Deeply clean the household dead angles such as sofa seam,
supporter, window corner, car interior and other inaccessible
seams.
Convenient for installation, easy for vertical cleaning and good for lumbar
vertebra health due to the one-key snap joint.
Easy for cleaning high places such as roof, air conditi
oner and curtain due to
matching with different brush heads.
Introduction and use method of accessories
After installing all the parts, turn on the
switch button at the handle to start the
cleaner (button in the figure)
The three gears of suction power can be
selected in turn as needed by pressing
the suction adjustment button on the
top of machine body. There are three LED
indicator lights on the button: the
blue
indicator light is for the low gear; the
purple
indicator light is for the middle gear;
and the
red
indicator light is for the high
gear. (as shown in the figure)
Connect the power adapter with the charging
interface in battery pack, and connect the
power supply to start charging.
(as shown in
the figure)
The three indicator lights will flash when
the machine is charging, and the power of
machine is full when the indicator lights are
normally on.
①
②
③
Start of cleaner
Adjustment of suction power
Condition of charging and indicator light
To Next Page
Loading...
