Troubleshooting
Fan overloaded
Left wheel overloaded
Right wheel overloaded
Left and right wheel overloaded
Left side brush overloaded
Left wheel and left side brush overloaded
Right wheel and left side brush overloaded
Left and right wheel, left side brush overleaded
Right side brush overleaded
L01x
L0x1
L0x2
L0x3
L0x4
L0x5
L0x6
L0x7
L0x8
Check if fan is pressed and clean dust bin
Left wheel and right side brush overleaded
L0x9
Right wheel and right side brush overleaded
L0xA
Left and right wheel, right side brush overleaded
L0xB
Left and right side brush overleaded
L0xC
Left wheel, left and right side brush overleaded
L0xD
Right wheel, left and right side brush overleaded
L0xE
L0xF
Check if it is stuck or wired
by obstacles
Error Code
Cause Solution
Left and right wheel, left and right side brush overleaded
Note: If above solution doesn't work, please try below:
1. Reset the robot by powering off it and then turn on it, and check again.
2. If it still not work after reset the robot, contact the after service.
Error codes for motorsError codes for motors
Service Guidance
If you have any questions about the product or this manual, please contact our
after-service team:
Tel: +86-512-8860 8088
Fax: +86-512-8860 8099
E-mail: Support@Dibea.com
Suzhou Dibea Electrical Technology Co., Ltd.
www.dibea.com
To Previous Page
Loading...
