Touchscreen Data Logger Quick Start Guide (DicksonOne) Page 6
Graph Settings
Display View: Toggle between a Graph and Text view on the home screen.
Display Statistics: Display minimum, maximum, and average on the home screen for any channels
displayed on the graph.
Vertical Scale Auto: Automatically scale the Y-axis based on the data or manually set the min/max
values for the variables.
Temp Min/Max & RH Min/Max: If you have Vertical Scale Auto set to “off” then you’ll need to
manually configure the Y-axis values for each variable.
Channels:
Display: Display this channel on the home screen (maximum of 2 can be displayed, but any
connected channels are recorded).
Min/Max: If this is turned on, you’ll see the high and low lines (lighter shade of the main line)
for the graph lines (an average depending on the amount of time displayed on the screen).
Alarm Settings
To configure the alarm follow these steps:
1. Enable the alarm (up to two per channel or one high and one low per channel).
2. Select an above or below condition to trigger the alarm.
3. Set the value the reading must be above or below in order to trigger the alarm.
4. Enable the audible alarm if desired (if disabled, a message will still appear on the screen).
Readings To Trigger (alarm delay): the number of readings that an alarm condition must exist until an
alarm is triggered. For example, if your Sample Rate is set to five minutes and your ‘Readings to
Trigger” is set to 2 readings, it means the device must be in an alarm condition for 10 minutes before it
will alarm.
Downloading Data
To download the data from your device plug in a USB flash drive and follow these steps:
1. Hit the Save to USB button
2. Select the desired export
a. CSV (All Channels on This Device) - This option will export all stored channels on the
device including those from old replaceable sensors (if the device wasn’t cleared) in a
CSV format.
b. CSV (Connected Channels) - This option will export only the stored channels for the
replaceable sensors currently connected to the device in a CSV format.
c. DicksonWare - This option exports a file with all stored channels on the device
including those from old replaceable sensors (if the device wasn’t cleared), is
compatible with the DicksonWare software and maintains 21CFR11 compliance.
To Next Page
Loading...
