DIEBOLD NIXDORF K-two - Important notes

K-two User Manual
3
4 Important notes
Devices supplied by Diebold Nixdorf comply with the relevant safety regulations for data
processing and information technology equipment, including electrical office equipment for
use within an office environment.
CAUTION
Whenever work of any kind is carried out on the device, as well as when
data cables are plugged in and unplugged, the device must be completely
disconnected from the power supply.
• The sockets of the house installation must be easily accessible.
• The device may only be repaired by authorized technicians.
• Unauthorized opening of the housing or inexpert repairs can result not only in
considerable personal injury, but will also invalidate your warranty and liability protection.
• Always consult the available documentation before performing any work on this device.
• If this device is brought from a cold environment into a heated operating room,
condensation may occur. The device must be completely dry before being operated. An
acclimatization period of at least two hours must therefore be observed.
• Always lay the supply leads and cables in such a way that they cannot be stepped on or
tripped over.
• Exchange damaged cables immediately.
• In order to completely disconnect the device from the power supply, use the circuit
breaker in the fuse box or building installation.
• Make sure that no objects (such as paper clips) can reach the interior of the device, since
electrical shocks or short-circuits could result.
• To avoid overheating, ensure that the K-two is adequately ventilated.
• Data cables should not be plugged in or unplugged during a storm.
• Keep the device away from vibrations, dust, humidity and heat.
• Ensure that any used parts are disposed of in an environmentally-friendly manner.
• In case of an accident (such as damaged housing, entry of liquids or foreign objects),
switch off the device and use the circuit breaker to completely disconnect the device from
the power supply.