Digatron DT-50J - Maximums by Time Segment; Playback Recorded Data; Resetting the Instrument; Powering Off the Instrument

G. Playback
F. Maximums by Time Segment (if using store switch)
4.
POW ER
EXIT
Return to monitor / record mode.
Select a time segment. See E. Time Segments
.
1.
Displays time data.
Press and hold to
view Event number.
Changes time segment backward or
forward. Displays flash when your shortest
segment is shown.
3.
OR
Displays engine data,
showing maximum
values for this time
segment.
2.
MAX
E
N
G
I
N
E
2A.
EVENT
T
I
M
E
2.
Press to view engine data.
Select a time segment. See E. Time Segments
.
1.
3.
PAUSE
PLAY
Begins playback of selected segment. Pause and
resume playback with each press.
If paused, steps through data in 0.1 second increments.
If not paused, press and hold to fast forward.
4.
POW ER
EXIT
7.
Press once to return to E. Time Segments. Press again
to return to monitor/ record mode.
If paused, reverse steps through data in 0.1 second
increments. If not paused, press to reverse. Hold for
fast reverse.
5.
Press and release to
cycle through up to
three sets of engine
data.
6.
MAX
E
N
G
I
N
E
6A.
Displays time data.
EVENT
T
I
M
E
MAX
E
N
G
I
N
E
SET UP
SET UP LIGHT
LIGHT
H. Reset (clear memory)
1.
PAUSE
PLAY
And Press at same
time.
2.
PAUSE
PLAY
Press when display flashes. Aborted if not
pressed within 10 seconds.
I. Power Off
The instrument will turn off automatically if it does not
receive any button presses or a tach signal.
1.
POW ER
EXIT
Turns instrument off if it is not recording or
receiving a tach signal.
OR
SET UP