Setting the LED Warning Lights
Multiple warning lights can be set to the same function, but only one function can be set to a light. Warning lights can be used for
adjusting your RPM at the line and as a tail light. They can also warn of high temperatures.
From monitor/record, instrument enters Set Up menu.
SEL will flash on the display.
1.
O
R
With SLL flashing, press either button
to enter Set LED Warning Lights.
3.
EVENT
T
I
M
E
MAX
E
N
G
I
N
E
POW ER
EXIT
7.
Press once to return to Set Up menu.
Press again to return to monitor/ record mode.
5.
O
R
Press either button to change the
number being displayed. Hold the
button to change the number faster.
O
R
Press either button to set next light.
Repeat steps 4 - 6 until all lights are
set.
6.
MAX
E
N
G
I
N
E
2.
PAUSE
PLAY
SLL will flash on the display.
4.
PAUSE
PLAY
Changes the function the light will correspond to.
EVENT
T
I
M
E
LIGHT
SET UP
SET UP
PC Software: Set Up & Analysis
All limits and warning lights can be set on your PC with our configuration software. This software also allows you to change which
function is displayed in each window. Recorded information can be downloaded to a PC. The instrument must be in Monitor/Record
mode, with no Tach signal when hooked up to a computer. The instrument does NOT need sensors hooked up. Software was
included with your instrument. Download software updates from www.digatronusa.com. Attach the download cable to the white
connector on your instrument. Attach the other end to any serial port on your PC. Then follow the computer’s instructions.
Recording
The instrument records in sessions called Events (shown by an E), which start each time the instrument begins recording. Within
Events, time segments (Laps, L on the display) are created with infrared beacon receivers and transmitters or with a store switch. To
end an Event your engine must be turned off, the Exit button must be pressed, or the Tach must go below 200 RPM (this value can be
changed on your PC).
To Next Page
Loading...