Start Vehicle. Instrument turns on and starts recording automatically
when a tach signal is received. Records for 2 hours, then records over
oldest data.
A. Power/Record
Instrument Functions
3.
POW ER
EXIT
Return to monitor / record mode.
D. Overall Maximums
Press
and
hold.
1.
MAX
E
N
G
I
N
E
2.
MAX
Press and
release to cycle
through up to
three sets of
engine data.
E
N
G
I
N
E
3.
Repeat steps
1 & 2 as
desired.
E. Time Segments within Events
1.
2.
PAUSE
PLAY
Shows time for the last recorded time segment. Time
segments are created with a manual store switch.
OR
Changes backward or forward one time
segment. Displays flash for the shortest
time segment.
C. Starting a New Event at the Line
1.
POW ER
EXIT
Press 2 times to stop current Event and start a new one.
This makes it easier to find the run during playback and
downloading. Flashing : indicates the instrument is
recording.
B. Tuning at the Line
Set lights to turn on in increments that make tuning RPM at the line
easier. See page 8 for instructions on setting warning lights. Lights
can also be used as a tail light.
LIGHT
SET UP
To Next Page
Loading...