53
and then rotate the key to START.
After the engine is started, release the key.
The key will automatically return to ON position.
Return the accelerator joystick and then run the engine at low idling speed under no-load
condition for 5min.
Stop of Engine
Important: Do not stop the engine suddenly under heavy load or during high-speed running.
Otherwise, it will result probably in overheating or blockage of engine. Do not stop the engine
hastily, unless in event of emergency.
Return the accelerator joystick.
Idle the engine for approximately 5min to stop the engine.
Operations of Machine Joystick Mode (ISO Mode)
Before starting operations, please carefully check and confirm the joystick mode to be used.
Warm up the engine (hydraulic oil)
It’s dangerous to operate the working device without warm-up (Hydraulic oil), as the working
device can’t respond quickly to the controls or will motion probably in unexpected manner and
the safety devices can’t work normally probably. Therefore, ensure to warm up the machine
sufficiently.
Slew leftward superstructure
Slew rightward superstructure
To Next Page
Loading...