61
Careful Retraction of Bucket Working Device
While retracting the bucket working device, take
caution not to impact the bucket with bulldozing
blade.
For deep digging operations, if the bulldozing blade is
in the front, take caution to prevent impacting the
boom and bucket with bulldozing blade.
During operations, place the bulldozing blade on the
rear of machine whenever possible.
Caution of Downward Digging with Bulldozing Blade
If it’s necessary to drive over obstacles, close the
bucket working device to the ground, drive the machine at low speed, and drive the machine in
such manner that the obstacles are in the middle of tracks.
Precaution for Traveling in 2nd Gear (High Speed)
This bulldozing blade is designed for simple bulldozing operations. Do not use the bulldozing
blade for deep digging. Otherwise, the bulldozing blade and the underframe may be damaged.
Driving the machine over obstacles (Including rocks and stumps) may apply high load onto the
machine body and damage the machine. Avoid driving over obstacles
On rugged roads, drive the machine at low speed and avoid the sudden startup, stop, and
direction change.
When the machine is traveling in 2nd gear
(High speed) and a load higher than set value is applied, the machine will automatically slow
down to 1st gear (Low speed). If the load is reduced, the machine will accelerate and return to
2nd gear (High speed). Please be noted that the traveling speed varies depending on the load
condition (For machine with automatic traveling gearshift reducer system).
Place the bulldozing blade in the front while traveling in 2nd gear.
To Next Page
Loading...
Need help?
General