62
Precaution for Operations of This Machine in Water
Immersing the rear of machine in the water as
shown in above diagram will result in the
rotation of radiator fan in the water to
damage the fan. It's prohibited to immerse
the rear of machine in the water.
Permissible water depth
Operate this machine in the water only when
the water level is not above the middle of
track shoe (1).
For those parts used in water for a long time,
add sufficient grease till the used grease is squeezed out.
Do not immerse the slewing support or body in the water or sand. If already immersed, please
contact your service dealer for checking.
Precaution for Traveling on Slopes
Do not drive the machine on a slope steep
enough to cause instability of machine.
Please be noted that, in the actual
applications, the performances of machine
on a slope will be deteriorated due to
severe working conditions.
While traveling on a slope, lower the bucket
to 20~30cm off the ground. While climbing
up a steep slope, extend the bucket working
device to the front position. In event of an
emergency, lower the bucket onto the
ground and stop the engine of machine.
While traveling on a slope, drive slowly in 1st gear (Low speed).
Keep the driver seat facing towards the upslope direction while climbing up a slope. Keep the
driver seat facing towards the downslope direction during downslope traveling. In both cases, pay
special attention to the ground ahead of the machine during traveling.
Do not reverse the machine down a slope.
Traveling Posture on Slopes Upslope Traveling
Do not change direction on a slope or lateral slope. Firstly, return the machine to a level ground
and then select another
path.
The machine may slip laterally while traveling on a gentle slope covered by grass or dry leaves or
traveling on a wet metal plate or frozen surface. Do not park the machine laterally on a
To Next Page
Loading...
Need help?
General