86
Install the cap (2).
Note: Add clean water (soft water) only to compensate the lost coolant due to evaporation. Add
the coolant (antifreeze) and clean water (soft water) of specified mixing ratio only to compensate
the lost coolant due to leakage.
Checking and adding of engine oil
Please stop the engine and wait for the machine to cool down before maintenance. Checking
Checking:
Open the engine hood.
Withdraw the engine oil dipstick (1) and wipe
it dry by a rag.
Insert the oil dipstick (1) to the end and then
withdraw again.
Check the oil on the oil dipstick (1). The oil
level shall be within upper limit (H) and lower
limit (L). If below the lower limit (L), add oil.
Adding:
Take out the oil filler cap (2).
Add oil till the oil level is within upper limit (H)
and lower limit (L) of oil dipstick (1). Both excessive and insufficient oil levels will cause
malfunction.
Tighten the oil filler cap (2).
Start the engine, run at low idling speed for 5min, and then stop the engine.
Check the oil level after approximately 10min.
Checking of fuel level
Do not smoke or use open fire while handling fuel or performing the operations of fuel system.
Do not disassemble the fuel tank cap or refuel while the engine is running or is not cooled down.
Do not splash fuel to any high temperature surface of machine.
Refuel the fuel tank in a well-ventilated place.
Any overflown fuel shall be wiped away immediately.
Do not top up the fuel tank. Leave an expansion space for the fuel.
Tighten the fuel tank cap securely.
Use correct fuel grade based on the season.
To Next Page
Loading...
Need help?
General