89
Lubrication of Working Device
Maintain the machine under the status shown in above diagram, lower the working device to the
ground, and then stop the engine.
Lubricate the grease fitting by a grease gun.
Wipe away excessive grease.
Records
After first 50h (For new machine only) Checking and adjustment of fan belt
Please stop the engine and wait for the machine to cool down before maintenance.
The engine, exhaust pipe, radiator, hydraulic pipes, sliding parts, and many other machine parts
are really hot when the engine is just stopped. Touching such parts can cause scalding.
Important: A loose belt can cause poor charging of battery, overheating of engine, or earlier wear
of belt. The over-tight belt will damage the water pump or bearing and alternator drive belt.
Important: Keep the belts away from all greases.
To Next Page
Loading...
Need help?
General