AnywhereUSB User Manual (90001085_F1) 73
AnywhereUSB/14
Dimensions
Length: 4.97 in (12.62 cm)
Width: 17.00 in (43.18 cm)
Height: 1.74 in (4.42 cm)
Weight: 40.00 oz. (1134g)
Environmental
Operating temperature: 32
o
F to 131
o
F (0
o
C to 55
o
C)
Relative humidity: 0% to 95% (non-condensing)
Power Requirements
The AnywhereUSB/14 uses single or dual 120/230VAC 50/60Hz power
input(s) through the rear IEC 60320 inlet(s). Redundant (dual) supply
enables it to support mission critical applications where uninterrupted
powering is a must. In case of redundant (dual) powering, both supplies
provide power to the device about evenly proportioned. When one of the
supplies crashes the other will provide the complete power to the device.
In case of single powering, use the left hand side inlet (rear view). The
maximum power requirement of the AnyhwereUSB/14 is 40W.
Hardware Interface Features
The unit provides 14 USB ports (standard A-type receptacles). The
downstream ports support Low-Speed, and Full-Speed downstream
devices.
The unit supports two Ethernet connectors (dual RJ-45) LAN1 & LAN2 for
mission critical applications (redundant Ethernet). The unit can switch
from LAN1 to LAN2 and vice-versa if any of them crashes. The primary
input is LAN1.
The unit also provides an RS232 UART Management port via a DB9
connector at the rear next to the network connectors.