AnywhereUSB Installation Guide (90000405 Rev. F) – Page 4
Configuring the Host PC
To configure a Host PC to access the Concentrator:
1. Launch the AnywhereUSB Configuration Utility from the Start menu. The utility
displays a list of all AnywhereUSB Concentrators on your local subnet and on any subnet
configured in the Discovery List.
2. After the AnywhereUSB Configuration Utility has been launched it will reside in your
system tray. To open the utility, double click the AnywhereUSB icon in the system tray. If
you try to start this utility from the Start menu and it does not launch, check the system
tray.
3. The Configuration Utility automatically discovers Concentrators on your local subnet. To
discover Concentrators on other networks, you must add their network address to the
Discovery list. Select Discovery List from the Edit menu. Add the Subnet addresses or the
IP address of the individual device to the Discovery List Manager. For example, to add the
Class C network 10.21.x, you must enter 10.21.1.255. Note that your routers must be
configured to pass subnet broadcasts.
To Next Page
Loading...
