Configure the device using the ConnectPort LTS web interface Configuration through the web interface
Digi ConnectPort LTS User Guide
41
n IP settings: For viewing IP address settings and changing as needed. See IP Settings for more
information.
n Network Services settings: Configure access to various network services, such as ADDP,
RealPort and Encrypted RealPort, telnet, SSH, HTTP/HTTPS, and other services. See Basic
Network Services Settings for more information.
n Socket Tunnel settings: Configure a socket tunnel used to connect two network devices: one
on the ConnectPort LTS device’s local network and the other on the remote network. See
Socket tunnel settings for more information.
n Advanced Network Settings: Configure the Ethernet Interface speed and mode, IP settings,
TCP keepalive settings, and DHCP settings. See Advanced Network Settings for more
information.
IP Settings
The IP Settings page allows you to configure how to obtain the IP address of the ConnectPort LTS
device. You can use one of the following methods to obtain the IPaddress:
n DHCP
n Static IP address
n Subnet mask
n Default gateway
Note Changes to DHCP, IP address, subnet mask, and DNS may effect your browser connection.
In addition, this page displays the IP addresses of the primary and secondary Domain Name System
(DNS) server for the ConnectPort LTS device. For more information on how to assign and use these
settings in your organization, contact your network administrator.
ConnectPort LTS has two Ethernet interfaces and you can enable or disable each interface separately.
Each interface has following settings:
n IPv4: Internet Protocol version 4 configuration.
l Do not use this interface: Choose this option if you do not want to enable IPv4 address
on this Ethernet interface.
l Obtain an IP address automatically using DHCP: Choose this option if you want to
obtain new network settings after you reboot the ConnectPort LTS device.
l Use the following IP address: Choose this option to supply a static IP address. You must
provide the IP address and subnet mask. Other items are not mandatory, but may be
needed for some functions (such as talking to other networks).
l IP Address: The IP address for the ConnectPort LTS device. The IP address is a 4-part id
assigned to network devices. IP addresses are in the form of 192.168.2.2, where each
number is between 0 and 255.
l Subnet Mask: The subnet mask for the ConnectPort LTS device. A common subnet mask is
255.255.255.0.
To Next Page
Loading...
Need help?
General