Digi ConnectPort LTS Series User Manual

Configure the device using the ConnectPort LTS web interface Configuration through the web interface
Digi ConnectPort LTS User Guide
81
n Enable Simple Network Management Protocol (SNMP) v3: Enables or disables use of SNMP
version 3.
l User: The user name that is authenticated to communicate with the SNMP engine.
l Security level: The security level of the user with regard to authentication and privacy:
Auth_NoPriv or Auth_Priv.
l Authentication protocol: The type of authentication protocol algorithm to use: MD5 or SHA.
l Authentication password/ Authentication password (confirm): Supply and confirm the
password for the user.
l Privacy protocol: The type of privacy protocol to use: DES or AES.
l Privacy password/ Privacy password (confirm): Supply and confirm the password for the
user.
l SNMPv3 Permission: Select the appropriate permission level: get only or get/set.
n Enable Simple Network Management Protocol (SNMP) traps: Enables or disables the
generation of SNMP traps.
l Trap version: The SNMP version for the trap.
l Trap primary IP: The primary IP address of the system to which traps are sent. You must
specify a non-zero value to enable traps. If your ConnectPort LTS product supports alarms,
this field is required in order to send alarms in the form of SNMP traps. See Alarms
Configuration.
l Trap secondary IP: The secondary IP address of the system to which traps are sent.
l Trap community: Community string for SNMP trap.
l Trap user: Type the user name that is authenticated to communicate with the SNMP v3
trap engine.
l Trap security level: The security level of the user with regard to authentication and
privacy in case of SNMPv3 trap: Auth_NoPriv or Auth_Priv.
Select one or more of the following SNMPtrap options:
n Generate cold start traps
n Generate link up traps
n Generate authentication failure traps
n Generate login traps
n Generate power traps
Date and Time Settings
Use the Date and Time Settings page to set the Coordinated Universal Time (UTC) and/or system
time and date on a device, or set the offset from UTC for the Digi device's system time.
n Enable NTP: Select or clear the check box to enable or disable Network Time Protocol (NTP).
When enabled, the ConnectPort LTS uses NTP to set the system time.

Digi ConnectPort LTS Series Specifications

General

Brand	Digi
Model	ConnectPort LTS Series
Category	Server
Language	English