Port Flag Configuration tab
The Port Flag Configuration tab allows you to configure performance options and special
functionality on a per-port basis.
n Low Latency (930-based Edgeport only):
Normally the UART will interrupt when the receiver has been idle for 4 character times
(for example, 4ms at 9600). As long as data is being received, the UART will continue to
buffer them until its internal FIFO is full (~56 bytes). This flag causes the Edgeport to
poll the RX FIFO for received bytes. If any bytes are available, they will be sent to the
driver without any delay.
n Remap Baud: Setting the baud rate to 1200 baud results in 230400 baud.
n Ignore Flush:
If an application sends IRP_MJ_FLUSH_BUFFERS, it will be ignored. The following is an
excerpt from Microsoft documentation:
Drivers of devices with internal caches for data and drivers that maintain internal buffers
for data must handle this request.
Edgeport USB Expansion Modules Installation Guide
17
To Next Page
Loading...