Regulatory information
Digi complies with all U.S. federal regulations for digital devices as well as the international
regulations described below.
Regulatory statements
For U.S. Government use:
Computer software is furnished with Restricted Rights in accordance with FAR 52.227-14. Technical
Data is furnished with Limited Rights in accordance with DFAR 252.227-7013 (b) (3) of the clause
entitled RIGHTS IN TECHNICAL DATA – NONCOMMERCIAL ITEMS.”
For non-U.S. Government use:
These programs are supplied under a license. They may be used, disclosed, and/or copied only as
supplied under such license agreement. Any copy must contain the above copyright notice and
restricted rights notice. Use, copying, and/or disclosure of the programs is strictly prohibited unless
otherwise provided for in the license agreement.
Radio Frequency Interface (RFI) (FCC 15.105)
This device has been tested and found to comply with the limits for Class B digital devices pursuant to
Part 15 Subpart B, of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential environment. This equipment generates, uses, and can
radiate radio frequency energy, and if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try and correct the interference by one or more of the following
measures:
n Reorient or relocate the receiving antenna.
n Increase the separation between the equipment and receiver.
n Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
n Consult the dealer or an experienced radio/TV technician for help.
Labeling Requirements (FCC 15.19)
This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
If the FCC ID is not visible when installed inside another device, then the outside of the device into
which the module is installed must also display a label referring to the enclosed module FCC ID.
Modifications (FCC 15.21)
Edgeport USB Expansion Modules Installation Guide
27
To Next Page
Loading...
Need help?
General