Digi WR31 - 4 Check Leds

How to test a WR31 router step by step.
Page | 16
4 CHECK LEDS
Connect both Ethernet ports to a switch.
Access the CLI (Command Line Interface) – this can be achieved:
 Through the serial port @115200 bps
 Via a telnet or SSH connection
 Via the “execute a command” page of the web user interface.
Issue the “flashleds” command and check that all LEDs are illuminated. If there is an LED fault please
request an RMA with code:
“x LED failure” where x is:
 Power LED
 SERVICE
 WWAN
 Signal III
 Signal II
 Signal I
 SYSTEM
 LAN 0
 LAN 1
The upper Ethernet LED will only light if a working network cable is attached.