Page 15
7.2.1 UPGRADE PROCESS
Make sure the battery on your Digifly Archimede is fully charged.
Turn off your Digifly Archimede and plug the Digifly PC serial or USB cable in to the
middle socket on the base of the Digifly Archimede.
Keeping the
key pressed, press the key and wait a long “beep” acoustic
confirmation. Note that the screen will not come on.
Now release the
key and then the key.
From your PC, run the “Upgrade_xx_x_Archimede.exe” program.
Press Start Button
Make sure you have only one version of the “Upgrade_xx_x_Archimede.exe” programme
open at a time.
When the “Upgrade_xx_x_Archimede.exe” tools software is operating you will see a the
progress of the software.
The upgrade process take about 5 minutes and on completion, your PC will confirm with
a long “beep”.
Press the
key and disconnect the PC cable.
When you restart your Digifly Archimede the version number of the new software you
have just installed is briefly shown on the start up screen.
To Next Page
Loading...
Need help?
General