Page 19
9.4 SETUP PARAMETERS
The following is a list of parameters that can be adjusted. For each parameter you can see the
range of values, the factory setting (default) and the unit of measure.
n Name Description Range Default Units
1 CTRS display contrast setting 40 - 60 53 %
2 V.UP acoustic vario lift setting 0 - 25 0.05 m/s
3 V.DN acoustic vario sink setting 0 - 25 3.5 m/s
4 TONE acoustic vario tone modulation SFT/STD/FAS STD ----
5 RVAR acoustic vario reactivity 0.1 - 3.0 0.4 sec
6 INTE vario integrator 0 - 60 1 sec
7 FS_V graphic vario scale(1,6,12 m/s) LOW/MED/HIG MED ----
8 SIMV vario simulator ON/OFF OFF ----
9 STAL stall alarm level 0 - 150 0 km/h
10 TEC total energy compensation 0 - 100 0 %
11 KIAS air speed calibration 50 - 200 100 %
12 KBAR barometer calibration +/- 20.0 0 mB
13 BARX graphic altimeter x scale 0.4 – 4.0 1 minute
14 BARY graphic altimeter y scale 3 - 3000 30 mt
15 HOUR time setting: hours 0 - 23 ---- hour
16 MIN time setting: minutes 0 - 59 ---- minute
17 DAY time setting: day 1 – 31 ---- day
18 MONT time setting: month 1 – 12 ---- month
19 YEAR time setting: year 0 – 99 ---- year
20 R-DS autorecorder meter 1 – 30 2 mt
21 PILO pilot name 6 characters ---- ----
22 U-AL altimeter, variometer units FT/MT MT ----
23 U-SP air speed units MHP/KMH KMH ----
24 U-TE temperature units FAR/CEL CEL ----
25 KTMP calibration temperature -20.0 +20.0 0 °C
26 LANG help language ITA/ESP/DEU/FRA/CZE/HUN/LN1/LN2 UK
9.5 RESTORE FACTORY SETTINGS
To restore the factory settings (default value for all parameters) press and hold down
the
key as you turn vario on. Keep the key pressed until a message “FACTORY
SET?” appears, then confirm with “YES” or “NO”.
To Next Page
Loading...
Need help?
General