Page 29
5.4 TEMPERATURE
The temperature can be shown by the Digifly instrument.
The ambient temperature reading can be shown in metric (°C) or
imperial (°F) units. To change the units of display, go to (MAIN
SETUP \ n. 30 U-TE) and change to “CEL” or “FAR”.
Temperature data can be shown in any of customizable display
fields (e.g. on the Thermal Display screen highlighted here in red).
To show the temperature data in any of these customizable fields,
press the
,
keys to highlight & select the data field you wish
to adjust.
As you scroll up or down, the fields that you can customize are highlighted (inverted)
and a description of the data currently being shown is that field is shown for approx 3
seconds.
To change the data you wish to display, press the
,
key. Each time the data field
is changed, the field briefly shows a description of the data type currently selected.
It is possible to adjust the temperature calibration, go to (MAIN SETUP \ n. 31 KTMP).
5.5 BAROMETER
The pressure can be shown by the Digifly instrument.
The pressure data can be shown in any of customizable display
fields (e.g. on the Thermal Display screen highlighted here in red).
To show the pressure data in any of these customizable fields,
press the
,
keys to highlight & select the data field you wish
to adjust.
As you scroll up or down, the fields that you can customize are
highlighted (inverted) and a description of the data currently being
shown is that field is shown for approx 3 seconds.
To change the data you wish to display, press the
,
key. Each time the data field
is changed, the field briefly shows a description of the data type currently selected.
It is possible to adjust the pressure calibration, go to (MAIN SETUP \ n. 12 KBAR).
Incorrect recalibration will makes the barometric altimeter readings less accurate.
To Next Page
Loading...
