Standard Keypad
Bolt Mechanism
Shared & Assigned Use Functionality
Product Guide
2
Programming Instructions
Setup
Locks are shipped with factory default settings (only operates by pressing
= `
). Each lock must be setup to operate with a Programming
Key and Manager Keys.
Insert the Programming Key.
A two-tone beep will be heard
and the LED will turn on.
Insert one Manager Key at a
time.
A beep will be heard for each
Manager Key programmed.
Insert the Programming Key.
A two-tone beep will be heard
and the LED will turn off.
Repeat above steps for each
lock or follow instructions to
Express Register Manager Keys
to setup all locks.
Express Register Manager Keys
The Programming Key can quickly program multiple locks to operate with the same Manager Keys.
Go to a lock already programmed to operate with the Manager Keys.
Press
= ` 6 1 `
.
The LED will turn on.
Insert the Programming Key.
A two-tone beep will be heard and the LED will turn off.
Insert the Programming Key to program each lock to operate with
the same Manager Keys.
Two sets of two-tone beeps will be heard and the LED will flash
twice to indicate successful programming.
End express registration mode.*
Go to any programmed lock.
Press
= `
then insert the Programming Key.
Press
= `
then insert the Programming Key again to return the
bolt to the original position.
*The Programming Key will continue to function in express registration mode until it is used to operate a lock.
1
1
3 4a
2
2 3 4
4b
To Next Page
Loading...
