Page 9 of 9
Troubleshooting
Always refer the LED Indicator table when troubleshooting.
The unit can be reset to factory defaults by following this procedure:
Reset to Factory Defaults
The IP Address information and all Intercom options can be reset to
factory defaults by the following procedure:
• Unplug the Power
• Press and hold the “Volume Up” and “Volume Down “ buttons
• Power the unit
• Wait till the unit plays a 3 tone beep (about 5 seconds)
• Release the “Volume Up” and “Volume Down “ buttons
• Refer to the software manuals for instructions on configuring the
IP address information
Contacting Technical Support
Information online at www.digitalacoustics.com
Email support:
esupport@digitalacoustics.com
Telephone Support:
+1 (847) 604-9256 Mon-Fri 8-6 (Central Time Zone)
To Next Page
Loading...
