Digital Acoustics IP7-FX

Other manuals for Digital Acoustics IP7-FX

Getting Started Guide4 pages

Need help?

Do you have a question about the Digital Acoustics IP7-FX and is the answer not in the manual?

Summary

Technical Specifications

Connections and Controls

Connector Pinouts

Replacing Older IP7 Models

Ethernet Network Connection

Powering the IP7-FX

Power over Ethernet (PoE)

Instructions for powering the device using PoE.

External Power Supply

Details on using 12VDC or 24VDC external power adapters.

Microphone Connections

Electret Microphone Setup

Guidance for connecting electret microphones to the IP7-FX.

Line Level Microphone Setup

Guidance for connecting line level microphones.

TalkBack Speaker as Microphone

Instructions for using a talkback speaker as a microphone.

Speaker Connections

Single 8 Ohm Speaker

How to connect a single 8 Ohm speaker.

Amplified Speaker or Analog Amplifier

Connecting amplified speakers or external amplifiers.

Multiple Speakers

Considerations for connecting multiple speakers for overhead paging.

Using 25;70 V Transformers

Guidelines for using 25/70V transformers with multiple speakers.

Configuration and Environment

Troubleshooting and Support

Resetting to Factory Defaults

Procedure to reset the IP address and intercom options.

Firmware and Support

Low Level Flashing Utility

Procedure for performing a low-level firmware flash.

Technical Support Information

Contact details and resources for technical assistance.