Digital-Ally DVM-250 Plus - User Manual

Copyright © 2014, Digital Ally, Inc. All Rights Reserved. This publication may not be reproduced, stored in a retrieval system, or
transmitted in whole or part in any form or by any means electronic, mechanical, recording, photocopying, or in any other manner
without the prior written approval of Digital Ally, Inc.
860-00198-00_WIP Rev A
March 2014
Wireless Link for and DVM systems
Operation and Installation Guide

Digital-Ally DVM-250 Plus Specifications

General

Category	DVR
Frame Rate	30 fps
Recording Format	H.264
Storage	SD Card
GPS	Yes
Audio	Yes
Power Supply	12V DC
Operating Temperature	-20°C to 60°C
Weight	0.5 lbs
Connectivity	USB

Summary

Before You Begin

Cautions and Notes

Important safety warnings and critical precautions to follow during VuLink installation.

VuLink Configuration

Configure VuLink and FirstVuHD using VuVault

Steps for configuring and activating VuLink and FirstVuHD devices via VuVault software.

Activate VuLink and FirstVuHD in VuVault

Procedure for activating both VuLink and FirstVuHD devices after configuration in VuVault.

Configure VuLink and FirstVuHD using Configuration Manager

Details on using the stand-alone Mini Configuration Manager software for device setup.

Configure DVM-800, DVM-250, and DVM-250 Plus Devices

Installation Instructions

Power Ignition and Ground Connections

Details on connecting the VuLink device to the vehicle's power and ground sources.

VuLink Trigger Connections

Guidance on connecting VuLink trigger inputs, including relay connections.

VuLink Installation

Model-Specific Wiring Diagrams

Operation

System Testing and Indicators

Support

Performing a Reset

Troubleshooting

Common issues encountered with VuLink operation and their suggested resolutions.

Product Repair

Warranty Information