Digital-Ally DVM-500 User Manual

DVM-500 User’s Guide Digital In-Car Video System
Digital Ally DVM User Guide Rev. F (334/1.6.2) Page 27 of 36
Power Control Menu (continued)
Ign. PowerUp Option
Installed - Turning the vehicle’s ignition switch to the ON position will
automatically power up the DVM. Turning the vehicle’s ignition switch to
the OFF position will cause the DVM to automatically power down after the
user-configured time has elapsed.
Note: This function requires a hardware modification to the
DVM. New DVM-500 systems can be ordered with the Ignition
PowerUp option installed. Existing DVM-500 systems must be
modified by Digital Ally, Inc. Call Product Support at 1-800-440-
4947 for more information.
Uninstalled – Choose this setting for DVM units without the Ignition
PowerUp option installed. The DVM can be powered up/down by
using the MARK button.
Delay in Record (mins)
A user-configured amount of time that must elapse before the DVM
can power down automatically after the vehicle’s ignition switch is
turned to the OFF position, while the DVM is recording a video. This
setting only applies if Ignition Shutdown is set to Enable.
Delay in Non-Record (mins)
A user-configured amount of time that must elapse before the DVM
can power down automatically after the vehicle’s ignition switch is
turned to the OFF position, while the DVM is idle (not recording). This
setting only applies if Ignition Shutdown is set to Enable.

Digital-Ally DVM-500 Specifications

General

Brand	Digital-Ally
Model	DVM-500
Category	Car Video System
Language	English