EDGEVIS HD-IP250 HARDWARE INSTALLATION
ISSUED: 10 NOVEMBER 2020 PAGE 3
Section 4 – Next Steps…
After unpacking the encoder, and wiring up your encoder the next step is
to perform the initial setup, where comms settings, server details and IP
Cameras are configured.
Setting up the encoder
With the encoder unpacked and all of the physical setup complete it is time to set up the encoder so that it is available
on the EdgeVis Server for viewing. Refer to the IP Series, HD-Q800, 4K-R800 - Setup Guide for further details.
To Next Page
Loading...