EasyManuals Logo

DIGITAL DELAY Mega 60 User Manual

DIGITAL DELAY Mega 60
9 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
3
Features and Specifications
Features:
• Microprocessor controlled timing
• Discrete I/O (input - output) construction
• Retains all numbers even with power disconnected from unit
• Large illuminated display for easy reading of information day or night
• Self-test mode on all display functions
• Dust & splash-proof backlit keypad with detent (positive feel)
• Hit the tree twice with one or two separate button
• Instant timing cycle reset
• Programmable push-button interrupt time
• Programmable Tap Up/Down feature for the delay (In pushbutton mode 1 or 3)
• Programmable Starting Line Enhancer (MEGA 85 w/ 4 Stage Timer only)
• Built-in drivers reaction tester
Specifications:
Input Voltage Range: 10 to 18 Volts DC (16 Volt compatible)
Operating Temperature Range: 0 to 150 degrees F.
Push-button Current: .1 AMPS at 12 VDC
• Two Separate Inputs
P.B. 1
• P.B. 2 or Tap P.B.
The Terminal Strip
+12VDC Terminal: Connect the +12VDC terminal to a switched +12 Volt source with enough amperage
capable of driving all outputs at the same time.
Transbrake Terminal: Connect the Transbrake terminal to the Transbrake solenoid.
Connect the low side of the 2-Step here, if used.
Ground Terminal: Connect the Ground terminal to the Neg. terminal on the battery or to good steel
ground, not
aluminum.
PB-1 Terminal: In Push-button Mode 3 the push-button connected to PB-1 terminal is used
to control the primary delay and the secondary delay in sequence. In Push-button Mode 1 & 2
the push-button connected to PB-1 terminal is used to control the primary delay only.
PB-2 Terminal: In Push-button Mode 2 the push-button connected to PB-2 terminal is used to control the secondary
delay only. In Push-button Mode 1 & 3 this terminal can be used for a Tap pushbutton connection.
After a Transbrake push-button has been released, every time the Tap push-button is depressed a programmable
amount of time is either added to, or subtracted from, the first delay time started until the transbrake is released.
Throttle Stop Terminal: Connect throttle stop wire to this terminal. This can be used as a
starting line enhancer or down track throttle stop controller. This is only on the MEGA 85 w/ 4 Stage Timer.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DIGITAL DELAY Mega 60 and is the answer not in the manual?

DIGITAL DELAY Mega 60 Specifications

General IconGeneral
BrandDIGITAL DELAY
ModelMega 60
CategoryControl Unit
LanguageEnglish

Related product manuals