9
NOTE
: It is assumed that you have already installed the bundled software into your
computer. If not, install software as instructed in the section on “Utility Software
Installation” of this manual.
Connecting the Camera to PC
To transfer (download) the images data
from the camera to your PC, connect the
camera to your PC with the supplied USB
cable.
1 Insert the smaller terminal of the
USB cable into the camera's USB
port.
2 Plug the other end of the USB
cable into the USB port of your
computer.
3 Perform downloads to your
computer by referring to the
section on “Downloading images”
later in this manual.
4 Operate the camera as web
camera by referring to the EyeStar
Mail section later in this manual.
To Next Page
Loading...
Need help?
General
