current rating.
Replace the the battery as soon as the insufficient battery indicator appears. Insufficient battery
power may cause incorrect meter readings
Please comply with local and national safety regulations, wear personal protective equipment
(qualified rubber gloves, masks, and flame retardant clothing , etc.) to protect yourself from
electric shock and arcing when live conductors are exposed
The voltage applied between the input terminals or between each terminal and the grounding
point shall not exceed the rated value specified by the Meter.
Measure a setpoint voltage to determine if the meter is operating properly.
Use the correct input terminal, function position and range position when measuring.
Do not use the Meter around explosive gas, vapor or humid environment
Do not use a damaged probe. Check if there are damage, exposed metal or signs of wear of the
insulation layer of the probe. Check the continuity of the probe.
When measuring, connect the neutral or ground wire first, then connect the live wire; when
disconnecting, please cut off the live wire first, then disconnect the neutral wire and ground wire.
When using probes, keep your fingers behind the finger guards on the probes.
Disconnect the probe and the objects to be measured before opening the back cover of the
Meter.
Do not use the meter in an environment that exceeds the measurement category (CAT) rating
of the individual component with the lowest rating in the meter, probe, or accessories.
Electrical Symbols
Warning of high voltage AC (Alternating current) DC (Direct current)
AC or DC
ARNING, important safety signs Earth ground
Fuse
Equipment is protected by double insulted or reinforced insulation Insufficient power of the
battery
Conforms to European Union directive
Do not discard such electrical/electronic products in household waste. Category II measurements
are suitable for testing and measuring circuits that are directly connected to the power points
(sockets and similar points) of a low voltage power supply unit.
Category II measurements are suitable for testing and measuring circuits connected to the power
distribution section of a building’s low voltage power supply unit
Category IV measurements are suitable for testing and measuring circuits connected to the low
voltage power supply unit ofa building.
Meter Indication
illuminator
To Next Page
Loading...