200Q 0.1 Q
±(1.0% + 3 )
2KQ 0.00lkQ
20KQ 10.0lkQ
200KQ 0.lkQ
2MQ 0.00IMQ
20MQ 0.0IMQ ±(1.2% + 15)
Overload protection:600V DC/AC RMS
Short press the key to switch to the capacitance measurement function.
Connect the two ends of the probes of the capacitors and read the measurement results from the
display.
Note: When measuring high capacitance, it takes time to stabilize the readings. Warning:
To avoid damage to the Meter or to the equipment under test, disconnected circuit
power and discharged all high-voltage capacitors before measuring capacitance. To determine
that the capacitor has been discharged adopting by the DC voltage file. automatically after about
15 seconds or press again and keep it manually for more than 2 seconds
Non-contact voltage detection , AC current and DC current measurement selection keys
Power switch and capacitance measurement selection button, long press to turn on or press
and keep more than 2 seconds to shut down. short press to switch to capacitance measurement
function, the meter will automatically cut off if there is no operation after about 15 min utes , and the
buzzer will alert I minute before shutdown.
Diode testing
IV 0.00IV
Forward DC current: about lmA; open-circuit voltage: about
2.8V
Display shows the approximate value of
diode forward voltage drop
Press the power button to turn on the meter and put the function selector switch at the position of
Overload protection:600V DC/AC RMS
Continuity buzzer
Connect the test leads in parallel to the circuit, power supply, resistor or diode to be tested. The
meter automatically determines the DC voltage, AC voltage, resistance,
Capacitance
Overload protection:600V DC/AC RMS
Testing conditions and diode.
To Next Page