Digital Projection E-Vision Laser 7500 & 8500 Series
Rev D January 2017
Page 17
Important Information
Removing the lens
Before changing the lens, always make sure the projector is switched off and fully
disconnected from its power supply.
When changing the lens, avoid using excessive force as this may damage the
equipment.
The lens is shipped separately.
Take care to preserve the original lens packaging and protective caps for future use.
The projector will not power on without the lens tted.
1. Push in the lens release lever, and turn the lens anti-clockwise.
2. Remove the lens.
To Next Page
Loading...
