47 | Chapter 1 : DVR User’s Manual
3.2.6 PTZ
Full control of PTZ cameras is available in this menu.
PTZ Menu (Depending on the model of PTZ camera): If selected, the OSD menu of PTZ camera is imported and shown on the
DVR monitor allowing the user to control the full PTZ settings.
Preset: 1 to 255 Presets are supported.
Protocol: Select the proper protocol of the connected PTZ camera.
Address: Set the PTZ driver address of the connected camera.
Baud rate: Select baud rate level from 1,200bps up to 115,200bps.
Check the below items for proper PTZ operation.
1 Check if the protocol of the connected PTZ camera is correct.
2 Check if the communication settings, including the baud rate, of the connected PTZ camera are in accordance with
the assigned value for that PTZ protocol.
3 Check if the address of the connected PTZ camera is correct.
4 Check if the wiring to the PTZ controllers is correct.
How to Setup PTZ Camera with Pelco-D Protocol (example)
1 Make sure the serial communication with the PTZ camera is through the RS-485 port.
2 Select [PELCO-D] at the protocol list, and set the address.
3 Select Baud Rate to be the same as the PTZ camera.
4 Click the [SAVE] button to confirm this configuration.
To Next Page
Loading...
