User’s Manual | 46
3.2.4 Motion Alarm
[MOTION ALARM] records only when DVR S/W triggers motion detection within the defined motion area.
If user sets Intensive to [ON], the DVR records at the maximum recording speed upon motion detection. Video will record for the
selected post-alarm dwell time, and pre-alarm video will record for the specified time. The selected sensor-out channel sends an
alarm signal.
Copy Settings: Upon pressing [COPY SETTINGS] button, the [COPY SETINGS] window will appear. Use this function to copy the
settings of a single camera to the other cameras. Select the camera to copy from, the properties you would like to copy and the
sensor numbers to apply the settings to. Click [OK] button.
3.2.5 Extra Alarm
SMART is an alarm signal triggered when the HDD is about to be out of operation. SMART Alarm is created by the HDD and is
captured by the DVR. If the HDD does not create this alarm, then the DVR cannot capture and output the signal.
Users can set the percentage for HDD Usage. When Usage is set to 50%, DVR will notify the user with a camera popup or a beep
sound when the HDD is 50% full.
To Next Page
Loading...
