Processor Jack
Attach one end of the included Controller cable here. Connect the other
end to your GSP unit’s Foot Controller port.
WARNING: Only connect the Control 2 Remote Foot Controller to
the GSP1101 or other DigiTech products which specify a connection to
the Control 2. Do not connect the Control 2 Remote Foot Controller
to Ethernet connections as damage will occur.
Expression 2 Input
Connect an optional expression pedal here using a 1/4” cable. A passive
expression controller or volume pedal is recommended.
1.
2.
Rear Panel
Control 2 Owner’s Manual
To Next Page
Loading...
