DigiTech CONTROL 2 User Manual

knob to select it.
To enable CC send and assign a MIDI CC that the CONTROL
Footswitch will transmit, highlight FC FSW and press the Edit/Select
knob.
Turn the Edit/Select knob to select a MIDI CC and press the knob to
select it.
Expression Pedal Calibration
In order to smoothly control parameters using the Control 2’s expression
pedal, the pedal needs to be calibrated the first time it is connected to the
GSP. This is done using the FC Pedal Calibrate menu in the GSP.
To calibrate the Control 2’s Expression Pedal, follow these steps:
From the preset screen, press the Edit/Select knob once to enter the
menu navigation system.
Turn the Edit/Select knob until the Foot Controller menu is highlighted
and press the knob again.
In the Foot Controller menu, highlight Pedal Calibrate and press the
Edit/Select knob to start the calibration procedure.
Once started, the Control 2’s Display will show TOE DOWN. Rock the
expression pedal full forward and press the flashing TUNER footswitch.
Calibration is now complete.
NOTE: You need to rock the Expression Pedal all the way forward and
all the way back each time you power up the Control 2 to re-establish
its Min and Max positions.
6.
7.
1.
2.
3.
4.
0
Control 2 Owner’s Manual
Using the Control 2 Remote Foot Controller

DigiTech CONTROL 2 Specifications

General

Brand	DigiTech
Model	CONTROL 2
Category	Accessories
Language	English